All the tutorials, troubleshooting tips and downloads - in one place.
Getting Started Topics:
1. Safety guidelines
Please review the following material to ensure a safe work environment and to maintain optimal machine performance.
The V-One is not only an excellent tool for the seasoned electrical engineer but it is also a great way to teach electronics. Never leave the V-One unattended while in use and supervise young and inexperienced users to ensure safe operation.
The V-One is for use as-is. Any modifications to the machine or improper use without explicit approval and direction from Voltera may damage the machine, may cause bodily harm, and will void your warranty.
In case of emergency or prior to performing any maintenance, please ensure power cable is disconnected from the V-One.
The heated bed is a multipurpose heater with a maximum temperature of 240°C that is used to dry printing materials and reflow solder paste. When the heater is on, the LEDs on either side of the V-One will glow red. While the LEDs are red, the printing platform is unsafe to touch and can cause burns. Remove any combustible materials from the area when heater is in use.
The V-One comes with 2 mL cartridges of printing material: conductive ink and solder paste. Do not ingest and keep these materials away from mouth and eyes. Be sure to wash hands well with soap and water before eating or drinking after handling. For more information, please refer to the Material Safety Data Sheets.
The V-One is an electromechanical device with motors, gears, and belts. Keep fingers away from moving parts.
The accessories included with the V-One contains sharp tools such as the probe and dispensing nozzles. Always keep the tip caps on the probe and the dispenser while not in use to prevent damage to the equipment and accidental injury
Ready to get started? Jump right in by following our printer setup guide.